forum.cncdrive.com

Hello everyone. Not been very active here lately, for many different reasons, but now I have a problem which I hope somebody can help me out with. My probe screens stopped working some times after version 1.2048. I tried to install the screens yesterday on version 1.2111 but the screen gets messed up and is totally useless. This issue been pointed out to me by several users and I was convinced that it was probably their fault, caused by not followed my manual, but yesterday I made my own test and they are right. The screen which should look like this:



But it looks like this instead, so it is completely useless.



Any idea or help is welcome. Was there a change in the way graphics are handled which I missed?

Thank you for any help.

Hi Josef,

Yes, there were a lot of changes in the screenset(s). The picture numbers that you use are also used by the default screenset. Use higher picture numbers. (1000+ or higher and you'll be safe for a long time.)

Hi,

Thank you very much. This should be easy for me to change.

Happy New Year and take care.

The problem is solved.

http://www.forum.cncdrive.com/viewtopic.php?f=9&t=538&p=24172#p24172

I managed to fix it this weekend. Thank you for the help.