The manual shows the AXBB sending 24 volts to stepper drivers.
Can the AXBB send 36 v or 48v?
I currently have 48V PSU, with a UC100 and G540. I am considering upgrading the UC100 to an AXBB.
Would I need to use special port or cable?
AXBB Max Volts to drivers?
3 posts
• Page 1 of 1
AXBB Max Volts to drivers?
by Zed_UCCNC » Sat Dec 05, 2020 10:51 pm
- Zed_UCCNC
- Posts: 38
- Joined: Wed Jun 24, 2020 1:15 pm
Re: AXBB Max Volts to drivers?
by ger21 » Sun Dec 06, 2020 12:49 am
Your 48V power supply connects directly to the G540, and NOT the AXBB-E.
The AXBB-E sends 5V step and direction signals to the G540.
The AXBB-E sends 5V step and direction signals to the G540.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: AXBB Max Volts to drivers?
by Zed_UCCNC » Sun Dec 06, 2020 3:05 am
Right you are. I misread this diagram from the user manual.
Thanks
Thanks
diag.pdf- (349.69 KiB) Downloaded 365 times
- Zed_UCCNC
- Posts: 38
- Joined: Wed Jun 24, 2020 1:15 pm
3 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 38 guests