forum.cncdrive.com

I have been using UCCNC for several months. Recently, when I load a file, the file load stretched and distorted. I attached a "capture" image to show you. The small blue lines at the very left are of the actual model to be milled. I then downloaded UCCNC on my regular laptop and loaded that same file and it loads correctly.

I then thought I could just delete the UCCNC I have and re-download and install it but then I would lose ALL of the settings/configurations I put in.
Can anyone tell me how to fix this?

Thank you for your help
Bill

Hi Bill,

Post your g-code too. Without the g-code I'm sure that it works fine: you are at 0,0,0 and the g-code contains some -X coordinates, far away from 0. UCCNC also displays the path from the current position to the workpiece.