Changed computer and can no longer connect to my UC300ETH
Posted: Thu Dec 26, 2019 3:07 amHi All,
You may have to guide me on this one!
I am normally a Mac user and not to comfortable with windows.
I just upgraded to a new PC and Installed a fresh windows 10.
I then proceeded to install the latest version of UCCNC.
Then copied both licences files from one computer to the other.
I then opened the UCxxx_utility. When I hit scan, My controller is found but when I test I get the following message: IP range or netmask setting is wrong!
When I start UCCNC, it is in demo mode.
I really dont know where to go from here.
Thanks for your help.
Merry Christmas all!
- Blaise
You may have to guide me on this one!
I am normally a Mac user and not to comfortable with windows.
I just upgraded to a new PC and Installed a fresh windows 10.
I then proceeded to install the latest version of UCCNC.
Then copied both licences files from one computer to the other.
I then opened the UCxxx_utility. When I hit scan, My controller is found but when I test I get the following message: IP range or netmask setting is wrong!
When I start UCCNC, it is in demo mode.
I really dont know where to go from here.
Thanks for your help.
Merry Christmas all!
- Blaise