forum.cncdrive.com

I am setting up a zenbot 2448 with UC100 and UCCNC software.
For the most part it is going great.
1. When I set all axis to 0 and the press the goto zero button, the Z axis gose to the top and hits the limit switch.
2. How to set the software to Inches?

Phillip

1.) Set the safeZ parameter in the configuration to the value which does not hit your limit switch.
2.) UCCNC is unitless. If you will work in inches then you setup the "steps per" values for inch length units.

Thank you CncDrive works perfect.