I am setting up a zenbot 2448 with UC100 and UCCNC software.
For the most part it is going great.
1. When I set all axis to 0 and the press the goto zero button, the Z axis gose to the top and hits the limit switch.
2. How to set the software to Inches?
Phillip
UC 100
3 posts
• Page 1 of 1
UC 100
by phillipknoll » Fri Nov 22, 2019 6:29 pm
- phillipknoll
- Posts: 2
- Joined: Fri Nov 22, 2019 2:21 pm
Re: UC 100
by cncdrive » Fri Nov 22, 2019 9:03 pm
1.) Set the safeZ parameter in the configuration to the value which does not hit your limit switch.
2.) UCCNC is unitless. If you will work in inches then you setup the "steps per" values for inch length units.
2.) UCCNC is unitless. If you will work in inches then you setup the "steps per" values for inch length units.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
3 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 17 guests