forum.cncdrive.com

M106 : Turns the spindle PWM on (Parameters P) The range of P is 0 to 255. This macro is used to control the FAN speed in 3D printing
M107 : Turns the spindle PWM off

Has M106 + 107 been removed from uccnc???

Any reason why, thanks?

{I was controlling a probe with it}

No, we did not remove it.

I was updating the macro manual and saw that it was not listed on the screenset help modes or within the manual, thanks I was just checking

I have also checked that afterwards I wrote my post and it is really missing from the help page and it is a mistake in the helpscreen.
The macros are still in the UCCNC, we did not remove them and I also verified that they are working.