forum.cncdrive.com

Why are their six different buttons to clear one DRO?
Button #182-#187 all apparently do the same thing? Clear DRO #169.

Yes, but there's only one Tool Length Offset DRO #, and all 6 of those buttons zero the same, single DRO.
If you use Button #182 on all 6 pages, it works the same as using a different button on each page.

Yes, but there's only one Tool Length Offset DRO #, and all 6 of those buttons zero the same, single DRO.
If you use Button #182 on all 6 pages, it works the same as using a different button on each page.

Yes, these now all call the same function inside the UCCNC setting the same DRO.
In earlier versions there were separated DROs per page, but we merged them, just did not merge the button numbers.