forum.cncdrive.com

Hello everyone !!! I’m new to this forum I want to start off I’m glad I found this form. I recently purchased
UCCNC machine control software I’m familiar with the fancu control
Just can’t get nothing to move in MDI. the numbers on the screen will move but no axis will

Is the blue light on the controller lit up?
Have you configured the port and pin numbers for your motors?

ger21 wrote:Is the blue light on the controller lit up?
Have you configured the port and pin numbers for your motors?

I’m not sure about the blue light I’ll check later today the only port & pin I feel I got right is for x , y , z, axis I can manually move them by just pressing the cursors on the Hidden screen all the way to the left
Where can I get information each port & pin for each functions?
So I’ll know where to start looking thanks

So you can jog them with the jog buttons, but they don't move in MDI?
What are you typing in the MDI?

ger21 wrote:So you can jog them with the jog buttons, but they don't move in MDI?
What are you typing in the MDI?

Correct !!

MarioChevelle wrote:

ger21 wrote:So you can jog them with the jog buttons, but they don't move in MDI?
What are you typing in the MDI?

Correct !!

Go x3 or Y2 or z3

Try G0

G-Zero. not G oh

ger21 wrote:Try G0

G-Zero. not G oh

Lol I did !!
I even tried the , insert after and nothing

Sorry, I have no idea what the issue is.

Did you hit enter after G0 x3 or G0 Y2?