Page 1 of 1
Re: Older UCCNC copy
Posted:
Tue Aug 07, 2018 9:30 pmby Robertspark
https://cncdrive.com/UCCNC.htmlTwo older versions are on the main page
I go as far back as 1.2026 (maybe a little older)
Re: Older UCCNC copy
Posted:
Wed Aug 08, 2018 1:33 amby ger21
I have 1.0034, 1.012, 1.1022, 1.1026, 1.1027.
Which one do you want? I can upload them and send you a link.
Re: Older UCCNC copy
Posted:
Wed Aug 08, 2018 2:00 pmby ger21
I'll get you a link this evening.
Re: Older UCCNC copy
Posted:
Wed Aug 08, 2018 2:16 pmby cncdrive
The 1.0034 is available for download on our website in the archives. It is the latest 1.0xxx version.
http://cncdrive.com/UCCNC.htmlJust fully roll down the page and you will find the link to the download.
Re: Older UCCNC copy
Posted:
Wed Aug 08, 2018 3:40 pmby dezsoe
Umm... It's interesting. I installed the 1.0034 from the link and it sais, it's 1.0034, but only knows the UC100. I have an old download from 2014 October, version 1.0034 and it already knows the UC300_5LPT. Both shows in help/about 1.0034, but they are completely different.
Re: Older UCCNC copy
Posted:
Thu Aug 09, 2018 12:39 pmby cncdrive
Make sure to delete the UCCNC.config file if you installed that early version over the 1.21xx version, because those new versions run on .net 4.0 and so the config file is required to allow to load 3rd party plugins,
but the old software installer does not delete the config file and also because it runs on .net 2.0 a config file is not installed.
And so if the new version's config file remains there then the app will crash because it tells Windows that the app requires .net 4.0 while it is .net 2.0 code.
Re: Older UCCNC copy
Posted:
Fri Aug 10, 2018 1:23 amby cncdrive
Then maybe the Flashplayer is missing from the computer or has the bug which was introduced at the time when we ported the whole UCCNC to OpenGL from Flash.
I did not follow up on if Adobe ever fixed that Flashplayer bug or not, because we no more needed it, so it is just a guess.