Re: Updating teh tool table via Scripting
Posted:
Mon May 21, 2018 10:05 amby Battwell
my m6 macro updates the tool table - tool length on every probed tool change?
i havnt tested diameter setting as i dont use g41/42 yet on the working machines
Re: Updating teh tool table via Scripting
Posted:
Mon May 21, 2018 11:42 amby cncdrive
Terry,
I think we can do an update function for those datas.
We were thinking that maybe the table would be better to be all on the screenset and not in separate Window, but it's just too much data, can be too long texts etc.
Anyways I'll check and figure a way to update it.
BTW, I've just made the macrorunning check function you asked some days ago, it will be in the next release.
Re: Updating teh tool table via Scripting
Posted:
Mon May 21, 2018 12:43 pmby cncdrive
I understand the problem and will make a function for updating them.