forum.cncdrive.com

On the UC300ETH-5LPT there is a jumper just above the 5v input socket. Can someone tell me what this jumper does and what position the jumpers should be in for an external 5v supply. My board was shipped with the jumper in a different position from some of the diagrams in the manual. I've looked for clarification both on the forum and in the manuals, but I seem to have missed them. Thanks.

Mike

Use the 2-3 position for UC300ETH. (The 5LPT card can be used with USB UC300 core and then you may get power from the USB port with 1-2 position.)

Thanks for the fast reply, just what I needed.

Again thanks,

Mike