Page 1 of 1
Getselectedindexinlist()
Posted:
Sun Apr 22, 2018 2:17 pmby Dan911
Is it possible to have a Setselectedindexinlist() function?
What I'm trying to achieve is a macro to automatically load my mm profile when Gcode loaded is in mm. I found no way of choosing a profile before Callbutton(190) to load profile.
Thanks,
Dan
Re: Getselectedindexinlist()
Posted:
Sun Apr 22, 2018 10:13 pmby cncdrive
Hi Dan,
Yes, we can add that function. Will try to make it for the next test release.
Re: Getselectedindexinlist()
Posted:
Mon Apr 23, 2018 1:26 amby Dan911
Thanks Balazs! As always cncdrive support can't be beat.
Hope your recovery is going smoothly.
Dan
Re: Getselectedindexinlist()
Posted:
Fri Jun 15, 2018 2:44 pmby Dan911
Thank you Balazs, I'm sure many will find use with this new function.
Dan
Re: Getselectedindexinlist()
Posted:
Fri Jun 15, 2018 2:45 pmby cncdrive
Thanks Dan. It took some time, but finally the function is available.
Please test it and let me know if you will find any problems with it.