M125 Px PREVIOUS Px value applied not latest Px value

[dammogreen]

Good , fast work by you, thanks.

I will use the double (or triple) M215 kludge or a delay maybe until it is fixed.

[dammogreen]

FYI,

I just tested something.

It has to be two M215 Px in a row like this:
M215 P1
M215 P1 (actual ratios are now applied for pulley 1)
M215 P2 (still on ratio for pulley 1)
M215 P2 (actual ratios are now applied for pulley 2)

--------------------------
a delay does not work, will not cause a pulley ratio change.

M215 P1
M215 P1 (actual ratios are now applied for pulley 1)
M215 P2 (still on ratio for pulley 1)
G4 P1 (1 second in my case, not mSec)
(still on ratio for pulley 1)

maybe some other commands like x movements will cause the type of delay that will work, did not test

[cncdrive]

This was corrected now in test release 1.2103, please test it and let me know if there is still any problems with it.

[dammogreen]

Yes, seems ok now.
G33 pitch distance moves correctly after just one M215 Px