UCCNC crashed with mach3 file with ignore unknown gcode
12 posts
• Page 2 of 2 • 1, 2
Re: UCCNC crashed with mach3 file with ignore unknown gcode
by merrick » Mon Aug 21, 2017 4:09 pm
I tried it again and it works fine, no crashing. I'm not sure what went wrong or corrected. I was working on some changes to the screenset at the time. Could it be?
- merrick
- Posts: 32
- Joined: Fri Aug 18, 2017 8:20 pm
Re: UCCNC crashed with mach3 file with ignore unknown gcode
by dezsoe » Mon Aug 21, 2017 7:38 pm
I don't know, but I tried everything I could imagine with your sample code and had no problem with it. 
- dezsoe
- Posts: 2093
- Joined: Sun Mar 12, 2017 4:41 pm
- Location: Csörög, Hungary
12 posts
• Page 2 of 2 • 1, 2
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 20 guests