Hi, first question. Profile fails to be created saying profile text field is empty and yet whatever I put in the text field gives the same error. I am importing a mach3 xml and trying to create a profile so I can load this whilst learning how to set up the default profile. looked in the manual and its not a lot of help.
Can anyone help please?
Tony
Profiles
3 posts
• Page 1 of 1
Re: Profiles
by cncdrive » Tue Jun 27, 2017 11:18 am
You have to press the Enter keyboard key to validate the input in DROs.
You can disable this behavior of the UCCNC on the Diagnostics/Appearance tab page and untick the Validate textfields with enter key only option and then Apply and/or Save the settings.
You can disable this behavior of the UCCNC on the Diagnostics/Appearance tab page and untick the Validate textfields with enter key only option and then Apply and/or Save the settings.
- cncdrive
- Site Admin
- Posts: 4887
- Joined: Tue Aug 12, 2014 11:17 pm
Re: Profiles
by X-man » Tue Jun 27, 2017 12:07 pm
Ah, thank you. I now seem to remember this from somewhere but getting old means the memory is not as good as it was. Thanks again for your help.
Kind Regards
Tony
Kind Regards
Tony
- X-man
- Posts: 24
- Joined: Mon Jun 26, 2017 5:10 pm
3 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: Bing [Bot] and 35 guests