New install UC300ETH issues

[tresguey]

Hello, I am new to CNC and am having issues connecting my computer to the breakout board.

I have a UC300ETH, I have the UCCNC software installed, my license saved in the folder. But I am still in demo mode. I went to my device manager and it does not see the board. I did try to use the UCXXX_utility app to configure, but it still does not see it. I try the test connection, but it always gives me an error saying the IP range or netmask is wrong. I save anyway, try to restart computer and the breakout board but still does not see it.

Any help is appreciated.

[cncdrive]

Ofcourse the device manager does not see your device, because it is a network device.
Please read the users manual about how to setup the network IP address for your device.
The motion controller's users manual describes it in details.

[tresguey]

Thank you, I got it now. I was looking at the wrong manual.