forum.cncdrive.com

UCCNC machine control software support forum

Skip to content

spindelmotor

If you have a question about the software please ask it here.
Post a reply

spindelmotor

Postby Tommy » Fri Sep 01, 2023 11:25 am

Is there a drawing on connecting spindle motor with a frequency converter to the UC300 ETH ?

Tommy Ollevik
Tommy
 
Posts: 2
Joined: Fri Sep 01, 2023 11:00 am
Top

Re: spindelmotor

Postby ger21 » Sat Sep 02, 2023 6:06 pm

It's going to depend on what breakout board(s) you are using.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
ger21
 
Posts: 2714
Joined: Sat Sep 03, 2016 2:17 am
Top

Re: spindelmotor

Postby Tommy » Mon Sep 04, 2023 8:20 am

UC 300 ETH board
Tommy
 
Posts: 2
Joined: Fri Sep 01, 2023 11:00 am
Top
Post a reply

Return to Ask a question from support here

Who is online

Users browsing this forum: No registered users and 14 guests

Powered by phpBB® Forum Software © phpBB Group