Statrup problems
3 posts
• Page 1 of 1
Statrup problems
by CornBrown » Sat Jun 10, 2023 4:14 pm
I was able to save settings for a night (reboot, reopen etc and settings were fine) then when I went to try it this morning, I needed to run the UCxxx IP tool to make uccnc open properly without a "xxx.pro failed to load" That seems to be where I'm stuck. Getting UCCNC to reliably load profiles or even open without having to run the ucxxx tool and then losing the settings. Cncdrive- Please help
- CornBrown
- Posts: 3
- Joined: Fri Jun 09, 2023 6:51 am
Re: Statrup problems
by ger21 » Sat Jun 10, 2023 5:38 pm
When you have UCCNC up and running, create a new profile and shortcut from within UCCNC and see if the new one works.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
Re: Statrup problems
by dezsoe » Sat Jun 10, 2023 6:53 pm
Can you make a screenshot of the error message? I can't recall a message like that.
- dezsoe
- Posts: 2093
- Joined: Sun Mar 12, 2017 4:41 pm
- Location: Csörög, Hungary
3 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: Bing [Bot] and 15 guests