this is my first post in this forum! So be kind please
I recently got an axbb-e to retrofit an old isel 3040. The board is amazing. Easy to wire and really easy to tune the software.
But I need to setup a measuring laser sensor to make some work for a client of mine.
I need to measure and save the data of a lot of point from a piece that I have to replicate. So basically I need to build a 3D scanner
Software side I don't have problems (I'm a software developer from my youth... and I'm near 40' now ?_? ).
I have found this nice laser sensor from Panasonic (I don't have bought the sensor yet). I think I can "easily" develop a plugin for UCCNC to implement my needs using this sensor.
https://www.tme.eu/it/details/hg-c1050-p/sensori-di-misura/panasonic/
and this is the pin out of the sensor
So basically other than the power supply for the sensor (24V) I have and 5V analog output.
Do you think I can wire the Analog voltage output to AI1 and the analog ground to the 5V0 (power out pin) of the board?
I found this in the manual... do you thinks is compatible with the wiring I want to make?
If this is possibile I "just" need to implement a loop with the reading of the analog value on the analog input and process the data to be stored in a 3D model.
But before to buy and expensive sensor and to maybe fry a controller I just want to be sure about the wiring