I’ve been using a UC100 with the UCCNC software on a System 45 controller from DIYCNC for quite a while now, I’ve been quite happy with the setup until recently the Z-Axis intermittently ignores the code and hence just ploughs through the job, but that’s another story!!!
I’ve now been building my own controller setup with:
UCCNC software
UC100
Benezan Mini BOB, inc. RJ45 adapters
4x Leadshine DM556 Drivers
No limit switches (for the moment)
Now my problem is I’ve been over everything and I can’t trigger the reset button, charge pump is working according to the BOB, but on the UCCNC diagnostic screen the LED is flickering.
Anyone have an idea, please.
Regards
Ian
- Reset Error
- Setup