Hello.
I‘m an absolute beginner with CNC.
I would like to control my YL620-A with my UC300ETH. I connected the following:
O1 (Channel 1) to VL1
O14 (Channel 1) to FWD
0V to GND
It don‘t works. Could anyone help me please?
Connect VFD YL620-A with UC300ETH UCBB
5 posts
• Page 1 of 1
Connect VFD YL620-A with UC300ETH UCBB
by Holztruhe » Mon Feb 28, 2022 9:50 am
- Holztruhe
- Posts: 2
- Joined: Mon Feb 28, 2022 9:37 am
Re: Connect VFD YL620-A with UC300ETH UCBB
by DavidR8 » Sun Mar 06, 2022 7:13 pm
Did you ever get this working?
- DavidR8
- Posts: 54
- Joined: Tue Feb 15, 2022 6:45 pm
Re: Connect VFD YL620-A with UC300ETH UCBB
by Holztruhe » Tue Apr 05, 2022 8:49 am
Hi,
no. I can messure different current and the steering signal occurs on the UCBB but the VFD don't shows any reaction.
Regards Stephan
no. I can messure different current and the steering signal occurs on the UCBB but the VFD don't shows any reaction.
Regards Stephan
- Holztruhe
- Posts: 2
- Joined: Mon Feb 28, 2022 9:37 am
Re: Connect VFD YL620-A with UC300ETH UCBB
by DavidR8 » Tue Apr 05, 2022 3:41 pm
What parameters have you changed on the VFD?
- DavidR8
- Posts: 54
- Joined: Tue Feb 15, 2022 6:45 pm
Re: Connect VFD YL620-A with UC300ETH UCBB
by Dazp1976 » Tue Apr 05, 2022 8:48 pm
Are you trying to use 0-10v control on the vfd?.
If so, the ucbb can't output a 10v pwm.
You need to either:
1. Use a pwm to analog converter from the ucbb.
2. Use the analog output port of the uc300 itself.
I'm using option 2 with my servo.
If so, the ucbb can't output a 10v pwm.
You need to either:
1. Use a pwm to analog converter from the ucbb.
2. Use the analog output port of the uc300 itself.
I'm using option 2 with my servo.
- Dazp1976
- Posts: 162
- Joined: Wed Mar 16, 2022 12:57 pm
5 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 64 guests