Going from uc100 to uc400th
2 posts
• Page 1 of 1
Going from uc100 to uc400th
by charliem » Wed Jan 18, 2017 12:12 am
Hello, I know my UCCNC software is licensed to my uc100. How would I go about upgrading to a UC400ETH or some other motion controller? Would I have to pay for another License?
Regards
Charlie M
Charlie M
- charliem
- Posts: 108
- Joined: Sun Jan 01, 2017 5:37 pm
Re: Going from uc100 to uc400th
by ger21 » Wed Jan 18, 2017 12:20 am
Yes. The license is tied to the motion controller.
You could always sell your UC100 with the license to recover some of the costs of the UC400eth.
You could always sell your UC100 with the license to recover some of the costs of the UC400eth.
Gerry
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
UCCNC 2022 Screenset - http://www.thecncwoodworker.com/2022.html
- ger21
- Posts: 2714
- Joined: Sat Sep 03, 2016 2:17 am
2 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 10 guests