Machine jerks in curves and corners

[dynaflux]

I have rebuilt an Omio X8-2200L-USB with a AXBB-E and UCCNC, however the machine jerks in curves and corners - has anyone encountered this problem and have a solution? I have tried some different settings but without improvement.

[ger21]

What are your CV settings? Increase the error tolerances.

[dynaflux]

I should mention those settings are imported from a XML Mach 3 - where it worked fine.

Comm. buffer size: 0.1
Constant velocity mode
Stop at angle degrees > 89
Look ahead lines count: 300
Lines error max: 0.03
Linear addition lenght max: 2
Corner error max. 0.03
Arc radius tolerance 0.1

[ger21]

Mach3 does not have most of UCCNC's CV settings, so they don't import.

Try increasing the two error max settings from .03 to 0.1.

[dynaflux]

Ok. Tried to change the values but couldn't see any significant change. Any other suggestions on improved settings?