Doing some re-wiring and accidentally shorted a ground wire. Now my UC100 stopped working--I get a green light but no blue light, and starting UCCNC I only get demo mode. Tried it on a different PC and still the same. Is there any hope or should I assume it's toast now? Is it possible to repair or just have to get a new one?
Thanks, Dan
UC100 power surge
2 posts
• Page 1 of 1
UC100 power surge
by dhanger » Sun Oct 13, 2019 9:43 pm
- dhanger
- Posts: 127
- Joined: Thu Aug 29, 2019 1:57 pm
Re: UC100 power surge
by dhanger » Mon Oct 14, 2019 1:21 pm
Issue has been resolved with CNCDrive support.
- dhanger
- Posts: 127
- Joined: Thu Aug 29, 2019 1:57 pm
2 posts
• Page 1 of 1
Return to Ask a question from support here
Who is online
Users browsing this forum: No registered users and 17 guests