Has CNC Drive tested the 5441 motherboard?

[ger21]

Since I've just found out that you have never tested the M44 board that I have, I was wondering the same thing about the 5441?
Have you tested one with the UC300ETH, and does everything work properly?

The 5441 seems to have all of the features that I want, but it is rather expensive.

I'm not sure how to go about purchasing one, though, as I can't read their website.
https://www.cncpart.hu/uc300-5441

I'm not interested in purchasing at this time, but if I do later, I'll contact them.

[cncdrive]

We have a 5441 breakout board here for testing.

I'm not sure if the CNCpart.hu guys talk english or not, but I'll talk to them and ask.
But in worst case we could get a 5441 board from them for you, if you will need one.

[ger21]

When the time comes, I'll contact you if I need one.
But I'd rather have the ISOBOB.