forum.cncdrive.com

Would it be possible to have the Toolpath show the X,Y & Z arrows on each of the views correctly?

139 Toolpathview45 Sets the toolpath to a 45° look viewing mode.
140 Toolpathviewright vSets the toolpath to a right side look viewing mode.
141 Toolpathviewleft vSets the toolpath to a left side look viewing mode.
142 Toolpathviewtop vSets the toolpath to a top side look viewing mode.
143 ToolpathviewISO Sets the toolpath to Isometric viewing

I noticed it after changing the toolpath for lathe X + Z, view / button # 141

142 & 143 look fine, its the others that look a bit difficult to read