forum.cncdrive.com

The first picture shows a straight line started with a ramped cut- notice the off co ordinate part at the bottom
The second picture shows a non ramped cut- perfect
No flex in cutter, work or head.
Any ideas

Can you post the g-code of the code which has the issue?

And your profile also please.

The title should be ramped cut starts
Strange thing is I can't see this movement on the dro. It is not in the code.
Machine is using servos- no overshoot. Very tightly tuned-

I would be happy to run your code on a logic analyser using your profile to see if there is any command on the other axis, but for that I will need the g-code file and your profile file.

I will post a snippet of the code tomorrow, it's part of a huge file

OK, but please make sure to post this exact part of the code and also don't forget to post your profile file.

email sent