forum.cncdrive.com

Hello,

I had very often the popup "The probe sensor was active.." during probing cyles drived by my plugin.

I read about the XHC-HB04 pendant interference. I disconnected the XHC (i use now a xbox-360 game controller), and de-activated the plugin.

I thought i solved the problem.

I just ran a 30 probes cycle. On the 29th, i have got the message.

Weird !

Seb

Not much to work with... Need more info.

Hello,

After investigations, it appears that the most probable cause of this reside in the stepcraft 3D touch gear.

Because i untighted the spring adjusting the sensitivity, sometimes the probe stay active after i move the head up.

I added a test before every G31 i generate : if the probe is active, a message ask the operator to reset the probe in "off" position.

I will get back here if i noticed something new.

Have a good day, and thanks for your attention.

Seb