forum.cncdrive.com

Today after several tests.
I came across a Big problem ..... I'll explain better.
Y axis in slave with dedicated limit switch.
I do a homing and everything is ok.
I press the physical Reset button and everything is OK.
I redo homing and everything is ok.
I jog and slave axis KO ..... does not move more .... Check the parameters and they are ok ....
What happens???
Version sw 1.2116

This bug was reported few times by various users including me. It seems to be fixed in latest version 1.2117..

richardk wrote:This bug was reported few times by various users including me. It seems to be fixed in latest version 1.2117..

I downloaded and installed version 1.2117, the bug exists but is not resolved

I rechecked the problem and it really seems to be solved in 1.2117 for me. That problem was the reason I downgraded from 1.2116 to 1.2115 before however now in 1.2117 it looks it works correctly for me. Perhaps the problem is also related to some specific configuration?

I check the settings, now I copied my configuration files and installed in version 1.2117. I could have made a mistake. As soon as I can I will do the tests