forum.cncdrive.com

Hi
I have a problem setting the Z axis homing
all the axes do homing well, except the Z axis which does not stop, it is set to "positive Dir" because it must go to find the reference point at the top
I tried everything and it's the same for all the other axes, if I set them to "Dir.positive" it does not stop when approaching the sensor, (NC inductive sensor mounted in series)
I tried to do the test by approaching a metal part while the axes are looking for homing, I have a message in the DIAG window stating that the home sensor is triggered, but the axis does not stop!
Do you have a solution?
thanks

I continued to solve my problem this morning
and I noticed that when I set the homing to “Dir positive”
the back off is not done in the right way....
instead of doing it in the opposite direction, it is done in the same direction as homing.....

I found the solution!!!
I had to put a negative value in the backoff -10 instead of 10