g80 doesnt seem to always clear g73
from mdi or code.?
g80 not always cancelling canned cycles.
2 posts
• Page 1 of 1
g80 not always cancelling canned cycles.
by Battwell » Sat May 27, 2023 9:07 am
Uc300eth on router and mill.
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
- Battwell
- Posts: 867
- Joined: Sun Sep 25, 2016 7:39 pm
- Location: South Wales. Uk
Re: g80 not always cancelling canned cycles.
by Battwell » Sun May 28, 2023 5:33 pm
user error 
post processor had G80 after G0
G80 must be before the G0 to cancel the canned cycle then set the new modal mode.
post processor had G80 after G0
G80 must be before the G0 to cancel the canned cycle then set the new modal mode.
Uc300eth on router and mill.
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
UK uccnc powered machine sales. https://cncrouter.uk/atc-cnc-routers.htm
Automateanything/duzzit cnc/mercury cnc
- Battwell
- Posts: 867
- Joined: Sun Sep 25, 2016 7:39 pm
- Location: South Wales. Uk
2 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 10 guests