forum.cncdrive.com

I had written a repeat probe routine that tracks led 224 probe hit
Had never noticed before but customer has!
The probe complete fails approx 1:30 times
Confirmed with stop after a failed led read.
I put the led on screen to confirm.
It doesn’t always set after a good probe.
( probe led is on and axis had stopped after probing as it should)
Weird that I have not caught this previously.
Ver 2.113

Does the customer have an UCR201 pendant?

No
Plug-in is disabled. ( I know that fault)

I believe that this is a known bug?

Download and install 1.2115 with the API bug fixed:

Here is a quick fix, this is the same as version 1.2115, but with the probe bug fixed: https://drive.google.com/file/d/1grm6MutYBom9WhEVK-zEW-cyG55w1w6z/view?usp=sharing
We released it under the same software version, because there are no changes compared to 1.2115 except this fix, so only the API version changed.

macro was re written to check probe led 37. ok since.

to confirm. led 244 doesnt always report correct in latest 115 version. (201 plugin fix version)