Hardstop of other axis, when softlimit is reached
Posted: Thu Feb 02, 2017 9:46 amHello,
i am using UCCNC 1.2031 with 2017 screen and UC400Eth.
If i move two axis manually and one axis reaches the softlimit, it slowes down with the correct decelaration, but the other axis stops immediately, without decelaration, but with a terrible sound.
Would it be possible to change it, so that every axis uses decalaration if one reaches the softlimit?
Thanks alot and kind regards,
Sven
i am using UCCNC 1.2031 with 2017 screen and UC400Eth.
If i move two axis manually and one axis reaches the softlimit, it slowes down with the correct decelaration, but the other axis stops immediately, without decelaration, but with a terrible sound.
Would it be possible to change it, so that every axis uses decalaration if one reaches the softlimit?
Thanks alot and kind regards,
Sven