Hardstop of other axis, when softlimit is reached

[svse]

Hello,

i am using UCCNC 1.2031 with 2017 screen and UC400Eth.
If i move two axis manually and one axis reaches the softlimit, it slowes down with the correct decelaration, but the other axis stops immediately, without decelaration, but with a terrible sound.
Would it be possible to change it, so that every axis uses decalaration if one reaches the softlimit?

Thanks alot and kind regards,

Sven

[cncdrive]

Yes, this problem has just been fixed, but was not release yet.

[svse]

Great to hear!
thumbs up!