Unknown G-Codes
Posted: Sun Jun 19, 2022 4:44 amHi Folks,
Newbie Alert.
I'm having an issue with the unknown G-codes option.
So we are all on the same page the following may be helpful.
Application: Plasma
Environment: XP-SP3, UCCNC 1.2115, NeuronLite Plugin, SheetCAM, NeuronTHCUCCNCPost.
Hardware: AXBB-E, UCSB, NeuronLite THC.
As a new user of all this stuff I have selected the UCCNC configuration option to warn if SheetCAM generates any G-codes that UCCNC doesn't support.
I created a simple square with a hole at each corner as a trial.
The file loads OK and when simulated (offline mode) a UCCNC dialog opens and prompts for confirmation of a required action - so far so good. (This would appear to be a modal dialog as nothing further happens until it is actioned.)
The unknown G-code in this instance is G21 - something to do with metric units - probably a SheetCAM post issue.
Moving on - the Run Screen for the Neuron plugin also includes a TEST button - the function of which is to execute the G-code file without actually firing the torch - very useful for newbies! - the challenge I'm having is that if I have UCCNC configured to respond to unknown G-codes and I select TEST, the previous action required dialog opens but I am unable to select an option - it would appear that the dialog loses focus and UCCNC just sits there unresponsive.
The only option is to exit via the X.
This is not a major issue as I can use it without the G-code warning option but I just thought you might like to know about it.
Newbie Alert.
I'm having an issue with the unknown G-codes option.
So we are all on the same page the following may be helpful.
Application: Plasma
Environment: XP-SP3, UCCNC 1.2115, NeuronLite Plugin, SheetCAM, NeuronTHCUCCNCPost.
Hardware: AXBB-E, UCSB, NeuronLite THC.
As a new user of all this stuff I have selected the UCCNC configuration option to warn if SheetCAM generates any G-codes that UCCNC doesn't support.
I created a simple square with a hole at each corner as a trial.
The file loads OK and when simulated (offline mode) a UCCNC dialog opens and prompts for confirmation of a required action - so far so good. (This would appear to be a modal dialog as nothing further happens until it is actioned.)
The unknown G-code in this instance is G21 - something to do with metric units - probably a SheetCAM post issue.
Moving on - the Run Screen for the Neuron plugin also includes a TEST button - the function of which is to execute the G-code file without actually firing the torch - very useful for newbies! - the challenge I'm having is that if I have UCCNC configured to respond to unknown G-codes and I select TEST, the previous action required dialog opens but I am unable to select an option - it would appear that the dialog loses focus and UCCNC just sits there unresponsive.
The only option is to exit via the X.
This is not a major issue as I can use it without the G-code warning option but I just thought you might like to know about it.