forum.cncdrive.com

After update from 1.2113 to 1.2115 it start giving the error. "The Probe sensor was active. The operation was aborted"
It is before start moving
It is both in Porbe screen and the Probe bottom.
In the diag. screen ti show not active and also in the Probe screen. If i press the probe it show active.
It is a UC300ETH board and a UCBB. And all other is running with out problem.
It is a win 10 64 bit pro.
I have try to set a Oscilloscope on the input and there is no noice or spike in the signal.

Are you using a pendant?
If yes then probably it causing it, we found a bug in the pendant interface which caused probing issues, it was already fixed, but the fixed version was not released yet.

Yes i have a RMC100(UCR200)

I start UCCNC and use keyboard to jog to probe position, then probe no problem.
Then i try to jog with the pendant and probe after and it failed.

When will ther be a update?

Hi when is there a update with this fix?

@cncdrive is there a time line with this fix? I am seeing thr same with ucr201.

We already fixed this, but it was not released yet.
We still working on the lathe mode for the UCCNC and when that will be done then we will make a new release which will contain this bug fix.
We hurrying with the new release as much as possible.

@cncdrive

No chance of a hotfix without the new lathe stuff?

Come on, we do not use the lathe function on our machines, it just allows for other errors, but our remote/pendant does not work, due to the error!
Please make a new release with only that fix. PLEASE

Here is a quick fix, this is the same as version 1.2115, but with the probe bug fixed: https://drive.google.com/file/d/1grm6Mu ... sp=sharing
We released it under the same software version, because there are no changes compared to 1.2115 except this fix, so only the API version changed.

Brillent thanks!