forum.cncdrive.com

Hello Balasz,

Mach3 V. 3.043.66, UC300ETH5LPT, Plugin 1.006 or 1.007
..
..
G91G31Z-20F300 (not supposed to trigger at this point, only approach move)
G0 X5
..
..
The axis moves but when poistion reached it freezes. If I hit the probe then it moves to next step.
Same behavior in VB script.
I have same application in other machine but UC300USB and works perfectly.
I need to catch up with my probing routine.

Thanks for help

Alberto FUL

Will verify this asap.

The issue with the probe with the Mach3 plugin when ran to endpoint without triggering the probe was fixed.
The problem was in both the UC400ETH and UC300ETH plugins, so I will attach both plugins for testing.

The UC300ETH test plugin attached here.

Thank You very much.The V1_008 works good.
Very efficient service.
Thanks again