forum.cncdrive.com

Hello Balasz,

Mach 3 r. 1.043.66, UC300ETH5LPT, probe input 4/10.
I need to use the probe to check position of piece to work.
G91G31Z-20F100 (It is suppose not to trigger at this point, this is only approach)
The axis move but when the quote is achieved then it stops. Only if I hit the probe then it executesto the next operation.
I have same application but wit UC300USB and works perfectly.
Pugin 1.006 (tried right now 1.007 found on the forum but same problem).

Pls help

Alberto FUL

Try Mach3 3.043.062.
Version .066 has issues with probing with other motion controllers.

Gerry,
Same behavior with 3.043.62.
It seems that it has to hit something anyway. It Waits until the probe input goes on.

UC300USB has no problem with 3.043.066
Neither UCCNC has problem with G31

This was fixed and test plugin posted in the duplicated thread: viewtopic.php?f=3&t=367