Version 1.2115 LED number errors
Posted: Fri Dec 31, 2021 2:35 amOn the Diagnostic page for the UC300-M44, all the LEDs are wrong for ports 2-5, except for pins 1&2 for port 2. All the rest use these same two LED #'s.
forum.cncdrive.com
UCCNC machine control software support forum
https://forum.cncdrive.com/
Version 1.2115 LED number errors
Page 1 of 1
Posted: Fri Dec 31, 2021 2:35 amRe: Version 1.2115 LED number errors
Posted: Sat Jan 01, 2022 8:11 pmThanks. Dezsoe will check it out, he is on holidays now, but will get back on the 5th.
Re: Version 1.2115 LED number errors
Posted: Mon Jan 03, 2022 12:06 pmi had reported to deszoe that the diagnostic pins for uc300eth 5lpt were wrong in version 113 too. i think he fixed those 
Re: Version 1.2115 LED number errors
Posted: Mon Jan 03, 2022 1:57 pmI went through most of them as I put the finishing touches on my new screenset, and I think that all the rest were correct.