forum.cncdrive.com

previously mentioned to deszoe.
im getting a fair amount of complaints about probe routines not correct in 114, 115 versions.
its as if the macro is skipping over the probe and going straight to the error of probe not hit.
also giving some strange probing results (not correct measurements)
most of these are from people who have ucr201 . (i think so far).
i saw this myself in 114 so rolled back to 113 and all is good in that version.

We will check it, thanks.

in case it makes a difference.
my probing routine switches to incremental.

Could you please post your probe macro?
And is the problem only happening if the UCR201 pendant is enabled?

Balázs, There's no problem with his profile or macros. In 2114 and 2115 G31 has issues when the UCR201 plugin is enabled. I have some log files and also Battwell's video uploaded to the NAS in PB's folder. Despite there is a new UCR201 plugin in the latest versions it's not the reason: we tested with the old UCR201 plugin and it does the same. The G31 sometimes even does not move at all but reports "probe didn't touch" in the probe result variable.