forum.cncdrive.com

Homing speed when an axis is slaved, not homing at set speed.

Well, it is a bug and not a bug.
The homing speed is always correct, only the displayed speed is not correct, but it works with the correct speed always.
The speed is not always correctly displayed, because in a master-slave homing sequence the axes are slaved and unslaved at some points when the gantry is squared and calculating the speed in all cases is not done correctly.
We will fix this later as it is not an urgent to get fixed issue because only the speed displaying is incorrect.

A bug and not a bug!

Thanks for clearing that up.

I am away from machine right now but will verify that when I return.

Got back to the machine today.

Put the scope on the step pulse and measured the speed with axis slaved and not slaved.

Confirmed for my own satisfaction that the bug is just of the displayed speed.

So that puts it to bed for me. Of no real consequence.