forum.cncdrive.com

Hi all,

I have set up offset on homing to define the origin of my table after homing and it works well !
However, when I click on Apply settings after any modifications, the offset on homing field is directly reset to 0. I don't know why ?

The following videos shows the matter :

https://www.loom.com/share/ec687e4812b147de86ca1db16152ba6d

Thanks a lot.

Fred

Hi,

This is because you have softlimits enabled and -10.75 is out of the softlimit range (0..3100). Change the softlimit- value to -10.75.

Thanks a lot.
Fred