forum.cncdrive.com

UCCNC version 1.2111
When homing UCCNC ignores other limit switches. If home input configuration is incorrect then machine runs past limit switches and crashes. I believe while homing it also should look on other limit switches.

How was the wrong setting?

Example.
I'm using limit switch as homing sensor. If i put X+ limit switch as X home sensor then machine goes past X- limit switch and crashes - it stops only when configured home sensor is triggered.

Another example. Homing X axis. While X axis is moving if i put something metalic to any of Y axis limit switches - i see Y limit switches triggering in diagnostics window, but movement is not stopped.

OK, I see, thank you!