Page 1 of 1
Pocket probing routine
Posted:
Wed May 06, 2020 9:17 amby Delco
Is anyone able to get the pocket probing routine to work , all fields filled in but it will not activate to enable a probe. Every other probing routine , ie simple , angle, circle inner outer and corner probes all work fine.
Re: Pocket probing routine
Posted:
Wed May 06, 2020 9:29 amby Robertspark
What version of uccnc?
Re: Pocket probing routine
Posted:
Wed May 06, 2020 9:29 amby dezsoe
Could you make a screenshot? There's no special setting. You have to enter a P1 value, fast and fine feed and fine distance.
Re: Pocket probing routine
Posted:
Wed May 06, 2020 10:31 amby Delco
Yep everyhting entered as per my normal probing , I have taken a screenshot of my settings - its on my home pc rather than the machine but its a cloned version with all the settings , as yes my machine is always home . Latest version 1.2112
Can anyone see if it works on thier machine , this will not even move a axis when start probe is pressed.
Re: Pocket probing routine
Posted:
Wed May 06, 2020 10:51 amby dezsoe
It seems to be set correctly. When you press Start probing what does it do? Any message? I've just tested the same version with your settings and it works fine.
Re: Pocket probing routine
Posted:
Wed May 06, 2020 11:33 pmby Delco
dezsoe wrote:It seems to be set correctly. When you press Start probing what does it do? Any message? I've just tested the same version with your settings and it works fine.
It does nothing at all ? , I deleted and reinstalled 1.2112 and it seems fine now on the same profile ???