Router SuperPID control with UC300ETH
Posted: Tue Mar 10, 2020 10:57 pmGood day, I have driver setup comprising of 1 UC300ETH, 2 HDBB2 drivers, 6 DG4S-08020 servo drives + 1 SuperPID router speed controller.
I have been having issues with router speed control when connecting SuperPID to output4 on either of the HDBB2 drivers, as well as to the analog port on UC300ETH. Furthermore I had the firmware of UC300ETH upgraded nd gone through the whole connection and test processes once more time. Also to make sure to eliminate any possible noises I rewired SuperPID out of the system, but no results. Every time having 0 control of the router speed, except when connecting to HDBB2 rpm is always at max without possibility of varying while connected to UC300ETH speed rpm are not proportional. All collections made in every situation were located to the same board to ensure common grounding. Please advise if this is a potential bug.
Thanks Marteng
I have been having issues with router speed control when connecting SuperPID to output4 on either of the HDBB2 drivers, as well as to the analog port on UC300ETH. Furthermore I had the firmware of UC300ETH upgraded nd gone through the whole connection and test processes once more time. Also to make sure to eliminate any possible noises I rewired SuperPID out of the system, but no results. Every time having 0 control of the router speed, except when connecting to HDBB2 rpm is always at max without possibility of varying while connected to UC300ETH speed rpm are not proportional. All collections made in every situation were located to the same board to ensure common grounding. Please advise if this is a potential bug.
Thanks Marteng
