forum.cncdrive.com

I use last ver software , and if i pull out the usb reciver of my chinese controller xbox , the software close without any notification , and if i start again i lost all origins , and cant retrive them .
I have to say the this happens , only when software is working , i mean after i press start .
I use win 10 64 bits , and uc400 eth .
Tested many times , and it does the same , please resolve this bug , i lost origins few time , and got a loot to work for finding stock origin again .

How are you using the xbox controller? With our xbox360 plugin or with a 3rd party plugin? Or?

Hi .
I am using with original plugin , more easy .
Uccnc was installed fresh on this pc .