Page 1 of 1
2017 screenset problem
Posted:
Mon Aug 26, 2019 7:05 pmby dedebiv
I'm using the 2017 screenset and a uc100. I can't change the kernel frequency, I found another post about this issue and an update to solve it, but i'm using the latest screenset version (1 week old), so the update is not working for me. Any tip?
uccnc v1.2049
2017 screenset v1.06
uc100
Re: 2017 screenset problem
Posted:
Mon Aug 26, 2019 10:53 pmby ger21
Did you copy all of the macros from UCCNC\Profiles\2017_Screenset_Macros into UCCNC\Profiles\macro_yourprofilename?
Re: 2017 screenset problem
Posted:
Tue Aug 27, 2019 5:49 amby dedebiv
Yes. The 25 frequency is always selected: selecting both 50 or 100 make the corresponding checkbox flash briefly, but then it always get back to 25. Added a line to the m99998 beginning, sending a message to chek if it runs on startup, and it does.
Re: 2017 screenset problem
Posted:
Tue Aug 27, 2019 10:47 amby ger21
Do all the other checkboxes work correctly?
It's working fine for me, and I've had no other reports of this issue.
Re: 2017 screenset problem
Posted:
Tue Aug 27, 2019 5:32 pmby dedebiv
Did a fresh new installation, now it’s working, thank you
