forum.cncdrive.com

Hi,

Not sure if this is a bug or something with my setup. Many times at first start up of uccnc software when jogging with arrow key a axis it will keep jogging after
releasing arrow key and will not respond to other key inputs.

Here is video:
https://youtu.be/KCowvUiwlDc

Is there something I can test or check?

This is the first time Im using this version. Never seen this on 1.2049.


Dennis

Post your profile file please.

Here it is

Did some more testing, if machine is homed first it will not self jog, did 10 restarts of uccnc and worked correct every time.

But if not homed, it will self jog and it does stop when Escape key pushed and after that everything responds correctly.


Been getting ready for Hurricane, I'm in central Florida. Checking the old trusty 1950's Fairbanks Morse generator. Still starts with
quick push of a button.

Good luck with the storm.
A stalled cat. 5 moving @ 1 mph ..... I pity the Bahamas.
Hoping it makes a hard right turn.
Russ