forum.cncdrive.com

Hi folks.
1.2109 Demo mode.
Configuration / Axis setup / Write Offset on Homing
The default download had X-0, Y-0, Z-2
I went to change the Z to 0 and it will not take. (hitting ENTER, of course).
I can enter any value other than 0 and it sticks in every axis but then trying to enter 0 in any of them, it reverts back to whatever the previous entry was. I now cannot get any axis Offset back to zero.
Is this a DEMO limitation ? or a possible BUG ?
Thanks for looking,
Russ

Works fine here, also in demo mode. Tried with UC100 Demo and AXBB demo.

FYI, you can disable the "ENTER" key requirement on the Appearance tab, if you so desire.

ger21 wrote:FYI, you can disable the "ENTER" key requirement on the Appearance tab, if you so desire.

Didn't notice that ..... (yet) THANKS !

Forgot to mention, AXBB her aas well.

Strange.
I'll try it with the ENTER disabled ... FWIW.
Thanks Gerry,
Russ

Are you clicking Apply Settings or Save Settings?

Yeah, I figured it out. Its a mini keyboard with the num pad overlying the qwerty keys.
With num lock on, 7,8,and 9 are the same but 0 is then an asterisk. Jeeeesh.
Turned the NUM LOCK off and its OK.
Thanks for taking the time Gerry, sorry.
Russ

I was going to say bad keyboard, but that was too easy, lol.